Tektronix 1750 NTSC Waveform/ Vector Monitor

(more pics at bottom)

The Tektronix 1750 functions as an NTSC waveform monitor, vectorscope, or SCH phase monitor.

NTSC Waveform/Vector Monitor

• Dual Filter/Simultaneous Display
• SCH Phase and Color Framing
• R-Y (V-Axis) Mode
• Remote Control Capability
• Line and field selection for VITS / ITS monitoring
• Comprehensive signal monitoring

CHARACTERISTICS

WAVEFORM MODE ( VERTICAL DEFLECTION SYSTEM )

• Deflection Factor: 1V input for 140 IRE display
• Gain Ranges: Input signals between 0.7 V and 2 V can be adjusted to 140 IRE

Frequency Response

• Flat: ±2% from 50 kHz to 6 MHz
• IRE: Conforms to IEEE Standard 205
• CHROMA: Response at 3.58 MHz does not vary between FLAT and CHROMA by more than 1%

Pix Mon Output

• Frequency Response: 50 kHz to 6 MHz
• Output Impedance: 75 ohms

Calibrator Signal

• Frequency: 100 kHz
• Amplitude: 1 V

WAVEFORM MODE ( HORIZONTAL DEFLECTION SYSTEM )

• Sweep: Sweep will occur in all Horizontal mode settings with or without synchronization
• 1FLD sweep repetition rate
• 2FLD sweep repetition rate
• 1H sweep repetition rate
• 2H sweep repetition rate

VECTOR MODE

• Chrominance Bandwidth:
  Upper: -3 dB Point Fsc +500 kHz, ±100 kHz
  Lower: -3 dB Point Fsc -500 kHz, ±100 kHz